Skip to main content

​
Two-Factor Authentication Setup for MoneyForward Cloud Services

Based on security requirements introduced by the service provider, two-factor authentication (2FA) is now mandatory. This applies to integrations with the following services.

​
Services Requiring Two-Factor Authentication

  • MoneyForward Cloud Accounting
  • MoneyForward Cloud Accounting Plus
  • MoneyForward Cloud Attendance
  • MoneyForward Cloud Fixed Assets
  • MoneyForward Cloud Contracts
  • MoneyForward Cloud Invoice

​
Steps to Configure

If you attempt to connect without two-factor authentication set up, an error will be displayed. The integration will then fail. Please follow the steps below to set up two-factor authentication and reconnect.
  1. Set up two-factor authentication on the MFID account used for the integration. For setup instructions, please refer to Two-Factor Authentication Setup Guide.
  2. After setting up two-factor authentication, reconnect with the relevant service. For reconnection instructions, refer to Connect a SaaS with two-factor authentication (2FA) enabled. Also see Re-executing the Integration.

​
If You Cannot Enable Two-Factor Authentication on Your Current MFID Account

Create a new MFID account dedicated to these integrations, set up two-factor authentication, and then reconnect.

​
If an Error Such as “Can’t access member list page!” Appears

This section applies to MoneyForward Cloud Attendance, Year-End Tax Adjustment, and MyNumber. The following errors may appear in these integrations.
  • Can't access member list page!
  • Cannot access the member list page.
These errors indicate a permission issue, not a two-factor authentication issue. They appear when the MFID account used for the integration cannot open the member list page of the target service. Check that the MFID account used for the integration has administrator privileges in the target service. Then reconnect with an MFID account that has administrator privileges.

​
If Reconnection Fails

If you are unable to reconnect successfully, please refer to When Reconnection Fails.
Last modified on September 30, 2026